Wildflower Silhouette

The following stamps were used:

7H184 Wildflower Silhouette
7F408 Wildflower Border

Paper & Ink Pads
White Cardstock
Watermelon 2-222
Mocha Divine 9-933
Chestnut Roan CB Chalk
Lipstick Red CB Chalk
Frost White CB Ink

Tombow Marker

Other
Foam Tape
Double sided tape
Ribbon JD33
White Emb. Pwdr.
Deckle Scissors
1 3/8" & 1 1/4' Sq. Punches

  1. Cut 7 1/2 x 5 1/2 piece of Mocha Divine CS. Fold 4 1/4" from right side to make card base.
  2. On inside right side stamp "Wildflower Border" using Frost White CB Ink. Emboss with white embossing powder. Heat set.
  3. Trim front right edge of Mocha Divine CS using deckle scissors. Layer 5 1/2 x 1" piece of White CS behind deckled edge.
  4. Cut 2 1/2 x 5 1/8 piece of White CS, Stamp "Wildflower Silhouette" on top portion, using Chestnut Roan CB Chalk ink. Layer to 2 5/8 x 5 W' piece of Watermelon CS.
  5. Cut 3 1/2" piece of ribbon. Put a small piece of double sided tape to center back of ribbon. Wrap approx. 1" piece of ribbon around center to form belt loop affect. Attached to stamped paper. Mount to card base using foam tape. .
  6. On White CS stamp "Wildflower Silhouette" using Lipstick Red CB Chalk Ink. Punch middle section using 1 W' square punch. Layer to 1 3/8" square, punched from Watermelon CS. Layer to card base.

These rubber stamp project instructions provided by Great Impressions.

Back to rubber stamp page