Cut 5 x 6 ¾ piece of Boogie Board CS. Fold
2 ¾ from top of card.
Apply 1 ½ “ dbl sided tape to bottom
edge. Remove backing, place a square of foam tape in middle of tape.
Sprinkle Twilight Blue “Glitter “ to
tape. Pat down to help stick to tape. Remove any excess.
Layer to 5 ¼ x 4 ¼ piece of Wild
Pansy CS. Layer a 5 ¼ x 1 piece of Strawberry CS to bottom back of card
so ¼” is left showing.
Cut 3 x 1 3/8 piece of Pistachio CS. Stamp
“By The Sea”using Vivid! Aqua Ink. Mount to bottom of card using the
foam tape square you attached in step #2.
Cut 4 ¾ x 2 ½ piece of Pistachio
CS. Stamp “Seaweed”using Vivid! Aqua Ink. Layer to top fold of card
base.
On White CS stamp “Clam Shell” using
Black Ink. Color as desired. Rub Versa Mark ink over entire image. Emboss with
½ glitter ½ EP mix. Heat set. Trim image. Using exacto knife cut
so Rachel will be able to sit in shell.
On White CS stamp “Rachel in The Sea”
using Black CB Ink. Emboss with clear embossing powder. Heat set. Color as
desired. Trim image. Attach Rachel to clam shell and mount to card base using
foam tape. Glitter as desired.
These rubber stamp project instructions provided by
Great Impressions.
