Mr. Scarecrow

The following stamps were used:

7H164 Peeking Sunflower

7G287 Scarecrow

7F336 Oak Leaf & Acorn Border

7E551 Too Cute Pumpkins

7E549 Golden Days

Paper & Ink Pads

White Cardstock

Blue Cardstock

Honeycomb Cardstock

Tuscany Stripe Paper

Black ColorBox Ink

Blue Iris CB Chalk Ink

Tombow Marker

098 Avocado

837 Wine Red

533 Peacock Blue

993 Chrome Orange

990 Light Sand

947 Burnt Sienna

Other

Glitter

2-Way Glue Pen

Foam Tape

Deckle Scissors

Clear Embossing Powder

Glue Dots

1. Cut 8-1/2 x 5-1/2 piece of Blue cardstock and fold in half for card base.
2. Cut 5-1/4 x 4 piece of Honeycomb cardstock and layer to card base.
3. Cut 3-1/2 x 3-3/4 piece of Tuscany Stripe paper. Trim top with deckle scissors and layer to card base.
4. Cut 3-1/2 x 2-1/4 piece of white cardstock. Stamp Scarecrow using Black CB ink, emboss with clear embossing powder and heat set. Color as desired.
5. Stamp Peeking Sunflower using Black CB ink on white cardstock. Emboss using clear embossing powder and heat set. Color the 2nd sunflower as desired and trim. Layer this to the scarecrow just below his suspenders.
6. Stamp Scarecrow again on white cardstock using Black CB ink, emboss with clear embossing powder and heat set. Color the arms only as desired, trim and mount over Scarecrow and Sunflower using foam tape. Layer to piece of Blue cardstock and layer to card base.
7. Cut 3-3/4 x _ piece of white cardstock. Stamp Oak Leaf & Acorn Border using Black CB ink, emboss with clear embossing powder and heat set. Color as desired and layer to 3-3/4 x 1 piece of Blue cardstock.
8. Mount to card base using foam tape and glitter as desired. Stamp Golden Days and Too Cute Pumpkins inside card using Blue Iris CB Chalk ink.

These rubber stamp project instructions provided by Great Impressions.

Back to rubber stamp page