Thanks – So Very Much

The following stamps were used:

7F308 Thanks Thanks Thanks!

7C357 So Very Much

7D340 Heart Overlay

Paper & Ink Pads

White Cardstock

Java Cardstock

Sweet Little One CS

Dune ColorBox Ink

Chestnut ColorBox Ink

Dusty Plum ColorBox Ink

Tombow Marker

Other

Glitter

2-Way Glue Pen

Ribbon

Stir Stick

Clear Embossing Powder

5/8" Hole Punch

Foam Tape

1. Cut 8-1/2 x 5-1/2 piece of Java cardstock and fold in half for card base.
2. Cut 5-1/4 x 4 piece of Sweet Little One cardstock and layer to card base.
3. Cut 3-1/2 x 1-1/2 piece of white cardstock. Stamp Thanks Thanks Thanks! Using Dune ink, emboss with clear embossing powder and heat set. Distress edges with Chestnut ink and layer to 4 x 2 piece of Java cardstock. Mount to card base at upper left corner.
4. Stamp Heart Overlay on white cardstock using Dusty Plum ink, emboss with clear embossing powder and heat set. Punch three hearts out and mount to card base on right side using foam tape.
5. Mount stir stick to bottom of card using foam tape. Slip ribbons under stir stick and tie knots. Push knots to left side.
6. Cut 2-3/4 x 3/4 piece of white cardstock stamp So Very Much using Dune ink, emboss with clear embossing powder and heat set. Distress edges using Chestnut ink and layer to piece of Java cardstock. Layer over right side of stir stick.

These rubber stamp project instructions provided by Great Impressions.

Back to rubber stamp page