Snow Frame

The following stamps were used:

7H159 Snow Fun Squares

7F300 Snow Frame

7F302 Dotted Tag

7D333 Winter is

7J86 Snowflake Border

Paper & Ink Pads

White Cardstock

Starmist Cardstock

Lava Cardstock

Limeade Cardstock

Birthday Girl Dots Paper

Black Memories Ink

Black ColorBox Ink

Lipstick Red CB Chalk Ink

Yellow Green Marvy Ink

Tombow Marker

925 Scarlet

845 Carmine

133 Chartreuse

451 Sky Blue

Other

Glitter

2-Way Glue Pen

Foam Tape

Clear Embossing Powder

Ribbon

1/8" Hole Punch

1-1/4" Circle Punch

Crystal Jewels

Glue Dots

1. Cut 8-1/2 x 5-1/2 piece of Lava cardstock and fold in half for card base. Stamp Snowflake Border using Lipstick Red CB ink on bottom of card front.
2. Cut 4-1/4 x 3-1/2 piece of Birthday Girl Dots and layer to card base. Wrap ribbon around left side.
3. Cut 3-1/2 x 2 piece of white cardstock. Stamp Snow Frame using black ColorBox, emboss using clear embossing powder and heat set. Punch center of "O" using 1-1/4" circle punch.
4. Stamp Snow Fun Squares using black ColorBox, emboss using clear embossing powder and heat set. Color upper right snowman as desired. Trim snowman from top right square and place behind the "O" from Snow and layer to piece of Starmist. Mount to Limeade and layer to card base. Attach Crystal Jewels using glue dots.
5. Stamp Dotted Tag on white cardstock using black ColorBox ink, emboss using clear embossing powder and heat set, trim. Color as desired, punch hole in tag and string ribbon through hole and behind ribbon from step 2. Mount tag using foam tape.
6. Cut 1-3/4 x 1-3/8 piece of white cardstock stamp Winter Is using black ink. Distress edges using Yellow Green Marvy ink and mount to tag using foam tape.
7. Glitter as desired.

These rubber stamp project instructions provided by Great Impressions.

Back to rubber stamp page