Happy Holidays
The following stamps were used:
- 7J82 Striped Tree
- 7F276 Happy Holidays Squares
- Paper & Ink Pads
- White Cardstock
- Pomegranate Cardstock
- Pear Cardstock
- Hunter Green ColorBox Ink
- Cranberry ColorBox Ink
- Sunflower ColorBox Ink
- Tombow Marker
- 899 Redwood
- Other
- Clear Embossing Powder
- Decorative Scissors
- Red Stars
- Gold Brads
- Red Gingham Ribbon
- Hole Punch
- Staples
- Foam Tape
- Cut 5- 1/4 x 8- 1/2 piece of Pomegranate cardstock
and fold in half for card base. Cut down I" from top on center fold. Cut
diagonally to a point 2-3/4" /Tom the bottom edge. Layer 4 x 5 piece of white
cardstock inside.
- Cut piece of white cardstock y.." smaller than the
front flap of the card. Cut 1 x 4 piece of Pear cardstock and layer to white.
- Cut 1-3/4 x 1-3/4 piece of white cardstock. Mask
the Striped Tree inking up the first four stripes from the top using Hunter
Green ink, emboss with clear embossing powder and heat set. Draw tree stump
using brown marker. Punc.h hole in center of star. Insert brad into red star
and then into star of tree. Layer to Pomegranate cardstock and mount over green
cardstock from step 2. Tie a knot in the ribbon and center the knot over the
Christmas tree, wrapping the ends over the edges of both sides. Layer to card
base.
- Mask Happy Holidays Squares and ink with
appropriate colors, emboss using clear embossing powder and heat set. Trim with
decorative scissors and layer each one on piece of 1-1/4 x 1-1/2 piece of Pear
cardstock. Punch hole in comer of stocking and insert brad and mount to card
front. Staple ribbon to other three squares and mount at top of inside of
card.
These rubber stamp project instructions provided by
Great Impressions.
Back to rubber stamp page