Buttons n’ Bulbs

The following stamps were used:

7H144 Bulb & Ribbon Border

7A108 Swirl

Paper & Ink Pads

White Cardstock

Deep Red Cardstock

Guacamole Cardstock

Rainforest Cardstock

Swirl Vellum Paper

Cranberry Color Box Ink

Tombow Markers

Other

Foam Tape

2-Way Glue Pen

Glitter

White Buttons

Avocado Green Ribbon

Clear Embossing Powder

1. Cut 6-1/2 x 5 piece of Rainforest cardstock and fold in half for card base.
2. Cut 4-3/4 x 3 piece of Swirl Vellum paper and layer to card base.
3. Cut 4 x 2-1/4 piece of Guacamole cardstock and layer to piece of Deep Red cardstock. Layer to card base.
4. Cut three 1" squares of white cardstock and layer to three 1-1/8" squares of Deep Red cardstock. Mount to card base using foam tape.
5. Mount buttons above each square using foam tape. Wrap ribbon around each button and tape to center of white square.
6. Stamp Bulb & Ribbon Border and Swirl on white cardstock using Cranberry ColorBox ink. Emboss using clear embossing powder and heat set. Trim and layer over the center of each white square.
7. Glitter as desired.

These rubber stamp project instructions provided by Great Impressions.

Back to rubber stamp page